Disclaimer::
This Site is Only for SUNIL V PAUL and his Family
1. സുനില്‍ .വി.പോള്‍ 2.സീന ആന്റണി ഒലക്കേങ്കില്‍ 3.ക്രിസ്റ്റ റോസ്.വി.എസ്. 4.ആല്‍ഫ്രഡ് പോള്‍ .വി.എസ്.

Any other person has no permission to access or alter or use the details of my site.
Neither SUNIL V PAUL nor HIS FAMILY is responsible for any error that may have crept in the ADDRESS OR DETAILS OF THE SITES being published on net
.

Monday, November 7, 2011

MY HOME

TOTAL 6 BEAMS
BELTS IS DONE ON THE BASEMENT NOT ON THE "THARA".
ALL BASEMENT AND "THARA" WORKS ARE DONE WITH ACC CEMENT NOT USING CLAY.
FOUR BEAMS AT FOUR CORNERS OF THE BASEMENT.
THE STAIR ROOM DOOR IS IN BETWEEN TWO BEAMS.(THE BEAMS ARE AT THE END POINTS OF THAT SIDE)
ALL BRICKS ARE "ARACHA KATTA" FROM KUZHALMANNAM.
99% PART OF THE CEMENT IS ACC AND REST IS MALABAR CLASSIC.
ALL WATER PIPES ARE ISI MARKED PIPES(STAR PIPE)
WATER TANK IS ISI MARKED TANK
ALL TAP CONNECTORS ARE BRASS
TILE IS STAIN FREE VITRIFIED(JOHNSON'S MARBONITE)
PAINT IS ASIAN CEMENT PRIMER.
WORK AREA TILE-REGENCY
BATHROOM FLOOR TILE-BELL
SINK IS MAYUR STINLESS STEEL
DOOR PAINT IS MAHAGONY-ASIAN
WINDOW BLACK PAINT-ASIAN
ALL BATHROOM ARE READY FOR ADDING HEATER-SEPARATE PIPES ARE PROVIDED FOR THAT(CVPC)
EARTHING IS DONE WITH SALT(25 PACKS),"KARI" AND SAND-BHARATHAPUZHA
THE LENGTH OF THE EARTHING RODS ARE 4 FEETS
THE COPPER WIRE USED FOR EARTHING HAVE 10MM GAUGE WITH HIGH LEVEL THICKNESS.(OR 8MM)
99% WORKS ARE DONE USING GOOD SAND.

MY WIRING

6MM VGUARD WIRES(4NOS)FROM METER BOARD TO DB
4MM VGUARD WIRES FOR ALL 5 AC POINTS
2.5MM V GUARD WIRES FOR ALL POWER PLUGS(MOTOR,INVERTOR,...)
1.5MM V GURAD WIRES FOR 99%OF INTERNAL WIRING
1MM VGUARD WIRES (ONLY 1 COIL=90METERS)STAIR ROOM
ALL BATHROOM PLUGS ARE DONE WITH 2.5MM WIRES
ALL A.C PLUGS ARE DONE WITH 4MM WIRES.

PAINTING

1).Buy cheap rate bed sheets from any reduction sale shop 10-14 sheets(or from sunday footpath),or buy sheet(tookku sheet) from any hardware shop.
2)Cover the entire floor with this cheap bed sheet or tookku sheet.it is better to cover all floor than clear the paint dots using putty blade or mukku blade.
3)Buy a putty blade(Rs.10) for removing the paint dots that may appear even after these preparation.
4)clean the floor regularly,remove all wastes as early as possible.it may save our tiles from scratches.
5)Give clean water for painting and remove the remaing water daily.
5)If we use desk,bench,stool or kuthira,Cover their legs using banyan cloth and old socks.